CONSTRUCTION— STARTER S1 14-3 1 5 Pinion assembly Shift lever Adjusting plate Plate thickness: 0.5 (0.020) 0.8 (0.031) Torsion spring C)e4-78 (0.65 – 0.80, 4.7 – 5.8) Magnet switch assembly OC) 74-98 (0.75 – 1.00, 5.4 – 7.2) Armature Stopper ip Gear case Brush spring metal —E=a(H) (O)4.9-6.4 (0.50 – 0.65, 3.6 – 4.7) Dust cover E-ring Field coil : Thrust washer Yoke Unit: mm (in) () : N-m (kg-m, ft-Ib) EBA) : High-temperature grease points Brush (+) Rear cover Rear cover metal (EES (H) Service Tips for 1988 Nissan Sentra Part Ill Courtesy Nissan Motor Co., Ltd. Starting System Magnetic Switch Check Before starting to check, disconnect battery ground cable. Disconnect “M” terminal of starter motor. First perform continuity test between “S” terminal and switch body. If there is no continuity, replace. From battery Ohmmeter Brush holder 5 5 Adjusting plate S1 1 4-440 Torsion sping Plate thickness: 0.5 (0.020) 0.8 (0.031) ©) 64-78 (0.65 – 0.80, 4.7 – 5.8) Pinion stopper Magnetic switch assembly Through-bolt Shift lever 4.9-6.4 (0.50 – 0.65, 3.6 – 4.7) Yoke Return spring Clutch assembly Bearing retainer Pinion shaft Field coil Unit: mm (in) 2) : N-m (kg-m, ft-lb) (A) : High-temperature grease points Brush (+) Brush holder Armature assembly Then perform continuity — test between “S” terminal and “M” terminal. If there is no continuity, replace. From battery “M” terminal Ohmmeter Pinion/Clutch Check Check to see if pinion locks in one direction and rotates smoothly in the opposite direction. If it does not lock (or locks) in either direction or unusual resistance is evident, replace. Adjusting plate Plate thickness: M3T26685 0.25 (0.0098) 0.50 (0.0197) Through-bolt Shift lever Lever spring 0 SD AN y , (0.25 – 0.45, Armature > =.) 7 Center bracket Rear cover metal i) ae Adjusting washer —s Cow. can Pinion assembly Washer thickiies® wie ru Ea Gear case 0.25 (0.0098) gana pring Unit: mm (in) 0.50 (0.0197) ©: N-m (kg-m, ft-lb) sia i @ Ea® : High-temperature grease point $114-440 Check pinion movement (S114-440 only). If it is hard to move, apply grease or, if necessary, replace.