chiwia . & | [| { 8 | anees / TECH TIPS Dixie Part Numbers: S-2055 S-2057 Applications: 1994 Mazda B3000 with calibration files listed below: – 4-55F-R10 – 4-55H-R10 – 4-55L-RO0O – 4-55L-R10 – 4-55M-ROO – 4-55M-R10 Note: The calibration code can be found on the certification decal located on the driver’s side pillar. Condition: The operator of the vehicle may complain of one ore more of the following conditions in colder temperatures (below the freezing point): – the engine stumbles after a cold start during acceleration – the engine stalls after the initial cold start – anextended crank cycle or hard starting after stalling – ano Start condition after stalling Cause: A potential cause for the above conditions is a faulty calibration file and/or power train control module. Correction: Verify that there are no diagnostic trouble codes stored in the system and correct the associated problems prior performing any work on the power train control module or the calibration file. Follow the manufactures recommended procedures when changing the calibration file or the power train control module. REV: 20100607 Courtesy of APRA TSB_263.doc Dixie Tech Tips are intended for use by professional technicians, and are not for the general public. They are written to inform technicians of conditions that may exist or as a guide to aid in diagnosing and servicing a vehicle. All references to original equipment manufactures, vehicle manufactures and any other Trade Mark names are for the sole purpose of identifying the vehicle and or part that the Tech Tip applies to. This document is property of Dixie Electric Ltd. and is not to be copied or distributed with out written permission.