1ode ) TECH TIPS Dixie Part Numbers: A-80344 TBA Applications: 2006 — 2008 Toyota RAV4 2008 — 2011 Scion xB Conditions: The operator of the vehicle may complain that the idler pulley is noisy when the engine is running. Cause: A potential cause for the above condition is the design of the factory installed idler pulley. Correction: Follow the manufacturer’s recommended diagnostic and repair procedures when applicable. The manufacturer has redesigned the idler pulley, brackets and washers to reduce the noise created by the idler pulley. The manufacturer began installing the updated bracket at the VIN noted below. The manufacturer’s part numbers are as follows: Models Affected Old Part # New Part Desciption Number All VINs require the idler 16603-28020 | 16603-28050 | Idler pulley pulley update. subassembly VINs earlier then: 16603-28030 | 16603-28031 | Idler pulley bracket XB JTLKE50E#81041289 RAV4 JTMZD3#V#85084220, JTMBD3#V#85139041, JTMZD3#V#86058407, JTMBD3#V#86060308 will require the new bracket Note: The kits are complete so only one kit of each is required. REV: 20120123 Courtesy of APRA TSB_8081.docx Dixie Tech Tips are intended for use by professional technicians, and are not for the general public. They are written to inform technicians of conditions that may exist or as a guide to aid in diagnosing and servicing a vehicle. All references to original equipment manufactures, vehicle manufactures and any other Trade Mark names are for the sole purpose of identifying the vehicle and or part that the Tech Tip applies to. This document is property of Dixie Electric Ltd. and is not to be copied or distributed with out written permission.