Keeping Lead Secure When Replacing Slip Rings COLUMN BY RICHARD R. VENSEL Slip ring replace- ment is a bigger part of your business than ever, and with the ever-increasing cost f to replace a rotor and the short life of some Mi slips, here are some simple mechanics to remember. 1. Test the rotor to ensure it is worth replacing the slip rings. We rec- ommend reading amp flow, mag- netic strength and doing an AC Hi Pot test at 500 VAC. After you have determined that you will be replacing the slip rings, cut the leads that come out of the pole pieces about one-quarter of an inch from the OEM weld or solder connection. This will give you a good surface to connect the new slip ring to. . Disconnect the leads from the slip ring to cut coil connection from the pole piece. Sometimes this may require cutting a slot through the steel fan with a Dermal and a cut off wheel. Some slip ring leads are held in place by a plastic upright protrusion, which can be cut right above the wire. This allows the lead to be easily pulled through the cut and when reassembled this plastic can easily be melted back together with a soldering iron or gun or reassem- bled with epoxy. . Measure and record the position of the inside slip ring to the pole piece or the end of the shaft and then remove the slip ring. Sometimes it pays to deepen the slot cut between the two seg- ments in the slip ring, so you have an easier place for the puller to fit (bearing splitter type). Slip ring removal requires a bearing separator and a two-jaw puller, a bearing splitter and a timing gear puller, a Jiffy Puller and a plate or two pry bars. 4. This step is very important and must be done. Clean the surface where the new slip ring will be located on the pole piece and/or fan. Sand blasting can be used to enhance the adhesive characteris- tic of the epoxy that will hold the leads in place. We recommend using a Dermal tool with a coarse wire wheel on it and then using 40 grit sandpaper to rough up the surface. Then clean the area with a fast drying non-petroleum base cleaner like isopropyl rubbing alcohol. This will ensure the best possible bond for the epoxy or cement you will be using. If this is not done, the epoxy will lift and crack. . Clean the contact point on the old connection that comes out of the 6. ~— pole piece. Cut the new slip ring leads so they will overlap the connection that comes out of the pole pieces for a better connection when sol- dered or silver soldered. . If you are going to solder the new slip ring to the old connection, tin (flux and melt solder over the connection surface) both slip ring leads and the old connection to the rotor coil. It is good to remember that some slip rings use steel instead of copper for the slip ring leads and the tinning process is a must in this situation. If you are going to silver solder the new slip ring in, make sure there is no solder on the surfaces to be silver soldered. Special note: Most solders like 40/60 and 60/40 melt at approximately 360 degrees F. These melting ranges are not working on some applica- tions today. There are solders that will take this temperature up to over 800 degrees F and are still