Traction Motor @, prestosite_“« SERVICE — Pagelof 2. en | INFORMATION Issued_3-16- VOLTAGE 36 ROTATION Reversible BRUSHES 4 POLES 4 VENTILATED No FRAME DIAMETER 6-5/8″ LUBRICATION None required. Prelubricated and sealed ball bearings used at both ends of motor, FIELD RESISTANCE (77°F/25°C) .010 to .012 ohms measured between terminals co a ee eS S-1l and S-2. ARMATURE TEST These armatures have standard winding connections and can be tested on a growler using a metal strip or hacksaw blade to locate shorted windings. COMMUTATOR Minimum diameter 2.875″. Replace armature when commutator has worn to this dimension. BRUSH REPLACEMENT Replace brushes when they have worn to a length ¢ of 9/16″ or less. fo SPRING TENSION 30 to 36 ounces with new brushes. Measure with a spring scale hooked under the brush spring at the brush. Pull the scale on a line opposite the line of force exerted by the brush spring and take the reading just as the brush spring leaves the brush. TEST CONNECTIONS CWDE . CCWDE Connect A-1 to battery positive Connect A-1l to battery positive oo; Connect A~2 to 5-1 Connect A-2 to $-2 Connect S-2 to battery negative Connect S-l1 to battery negative TEST SPECIFICATIONS (77°F/25°C) Test in both directions of rotation. Terminal Maximum Torque Voltage Amperes RPM Fe. Lbs. No Load Test 24 20 4130 min. -0O- Light Load Test 36 56 2880 to 3220 3 UNITS oo MKF-4001,A File in the | t . s 5 . | Printed In USA. L-600 SERVICE MANUAL > raction Motor Section MKF Continued ©, prestol/ite. SERVICE INFORMATION VIEWED FROM COMMUTATOR END } Nae