pX _INFORMATION prestoalte,_srr Traction Motor SERVICE Page 1 of 2 Issued 3/16/78 24 VOLTAGE VENTILATED LUBRICATION ARMATURE TEST COMMUTATOR BRUSH REPLACEMENT SPRING TENSION Yes ROTATION Reversible BRUSHES 4 POLES 4 FRAME DIAMETER 5-1/2″ None required. Prelubricated and sealed ball bearings used at both ends of motor. These armatures have standard winding connections and can be tested on a growler using a metal strip or hacksaw blade to locate shorted windings. Minimum diameter 1.602″. Replace armature when commutator has worn to this dimension. Replace brushes when they have worn to a length of 5/16″ or less. 20 to 22 ounces with new brushes. Measure with a spring scale hooked under the brush spring at the brush. Pull the scale on a line opposite the line of force exerted by the brush spring and take the reading just as the brush spring leaves 1-490 SERVICE MANUAL the brush. TEST CONNEGTIONS CWDE Connect – negative terminal to battery positive Connect + positive terminal to battery negative CCWDE Connect + positive terminal to battery positive Connect – negative terminal to battery negative TEST SPECIFICATION (77°F/25°C) Test in both directions of rotation. Terminal Maximum Torque Voltage Amperes RPM Ft. Lbs. No Load Test 24 15 3800 – 0 – Stall Torque Test 6 35 -~ 0- 4.75 File in the LL» Traction Motor Section MPF Continued (-f olte. AX prest Traction Motor Page 2 of 2 SERVICE Issued 3/16/78 INFORMATION UNIT MPF-4001 Note – Thermal protector not illustrated in wiring diagram. 4) — = =— ae VIEWED FROM COMMUTATOR END