ERA Office: Monday – Friday 9:00-5:00 CST

636-584-7400

office@electricalrebuilders.org

ERA Tech Helpline: 636-584-TECH (8324)

chiwia . & | [| { 8 | anees / TECH TIPS Dixie Part Numbers: A-1289 A-1371 A-8260 A-8470 A-8471 S-1363 S$-1395 S-8418 S-8476 Applications: 1988 — 1994 Isuzu Pickup Condition: Cause: 1988 — 1994 Isuzu Trooper The operator of the vehicle may complain of one or more of the following conditions: – The vehicle has low battery power. – The alternator has low out put. – The engine is hard to start or fails to start. A potential cause for the above conditions is the wiring harness on the rear of the alternator. From the factory the wires were routed through a metal retaining clamp. Vibration can cause the insulation to be rubbed off by the metal retaining clamp. Correction: The manufacturer suggests the following repairs: REV: 20100324 – Remove the wires from the wire retainer. – Insulate the wires with a thick covering to prevent chaffing (replace the wires if the conductors are damaged or corroded). Use electrical tape and loom to protect the wires. – Re-route the wires away from the rear of the alternator. Courtesy of Dixie Archives TSB_149.doc Dixie Tech Tips are intended for use by professional technicians, and are not for the general public. They are written to inform technicians of conditions that may exist or as a guide to aid in diagnosing and servicing a vehicle. All references to original equipment manufactures, vehicle manufactures and any other Trade Mark names are for the sole purpose of identifying the vehicle and or part that the Tech Tip applies to. This document is property of Dixie Electric Ltd. and is not to be copied or distributed with out written permission.

File Type: pdf
File Size: 673 KB
Categories: dixie