“dixie verse gy TECH TIPS Dixie Part Numbers: TBA Applications: 2010 Cadillac SRX Condition: The operator of the vehicle may complain of one or more of the following conditions: – The engine fails to start. – The fuel gauge operates erratically. – The malfunction indicator lamp is on. – There is water on the driver’s front floor area. Cause: A potential cause for the above condition is water leaking into the vehicle and or terminals at connector X350, which is located on the floor, just in front of the driver’s seat. This may cause the terminals to become corroded. Correction: Follow the manufacturer’s recommended procedures for inspecting and repairing the corroded harness, if applicable and determine the source of the water. If the source of the water is the fuel tank to harness pass through connector a newly designed kit is available manufacturer’s part number 19178098. If the terminals are damaged they should be replaced with manufacturer’s numbers 12047581 and 12034047. REV: 20110317 Courtesy of APRA TSB_197.docx Dixie Tech Tips are intended for use by professional technicians, and are not for the general public. They are written to inform technicians of conditions that may exist or as a guide to aid in diagnosing and servicing a vehicle. All references to original equipment manufactures, vehicle manufactures and any other Trade Mark names are for the sole purpose of identifying the vehicle and or part that the Tech Tip applies to. This document is property of Dixie Electric Ltd. and is not to be copied or distributed with out written permission.